Mr-Glass Window Replacement Nationwide | TruePane Windows & Doors

Mr-Glass Window Replacement: The Plantation Owner’s Guide

We stock and install Mr-Glass-compatible replacement windows throughout Plantation, with most units priced between $450 and $1,200 installed depending on size, glass package, and frame condition. A standard single-hung or fixed Mr-Glass window swap typically takes one visit, and our trucks carry common sizes for same-week scheduling. Most Plantation homeowners discover a failed Mr-Glass unit the same way: a window that suddenly fogs between the panes, a sash that drops when you let go of it, or a room that feels ten degrees warmer than the rest of the house in August. The seal fails first. Everything else follows.

Call (772) 577-2915

Which Mr-Glass Models This Applies To

Mr-Glass built windows under several series names over the years, and the replacement path depends on which one you have. The older single-hung aluminum frames common in 1980s and 1990s Plantation homes take a different sash profile than the later vinyl-line models. If you still have the original paperwork, look for the series code printed on a sticker along the sash edge or inside the frame track. No sticker? Measure the visible glass width and height to the nearest eighth of an inch, then measure the frame depth. That depth measurement matters more than people expect, because Mr-Glass used at least two frame depths across their vinyl and aluminum lines, and a sash that is off by a quarter inch will never seat correctly.

On the OEM-versus-aftermarket question, the honest answer is that Mr-Glass original parts are increasingly hard to source as the brand has aged out of much of the South Florida supply chain. We carry quality aftermarket sashes and glass packs that match the original sightlines and thermal specs, and in many cases they outperform the original seal design. We also stock compatible parts for PGT, CGI, and CWS units. TruePane Windows & Doors is an independent service provider, not affiliated with Mr-Glass, and we will tell you plainly when a full frame replacement makes more sense than a part swap.

Signs Your Mr-Glass Window Replacement Is Failing

• Fog or condensation between the panes. The seal around the insulated glass unit has broken and moisture is now trapped inside. This is the number one failure we see in Plantation because high humidity and daily thermal cycling work the seal hard year-round.
• The sash drops or will not stay open. The balance system, usually a spiral or block-and-tackle assembly in Mr-Glass windows, has lost tension. A window that slams shut is past the point of cleaning and adjusting.
• Visible water staining or soft wood around the interior sill. The weep system is clogged or the frame joint has opened. By the time you see the stain, water has been getting in for a while.
• You can feel air moving around the closed sash. Weatherstripping has compressed or the frame has racked out of square. In a Plantation summer, that draft is cash leaving the house every month.
• The window is hard to open or locks in place. Aluminum frames corrode and vinyl frames can warp under direct South Florida sun. At a certain point the track is no longer true and no amount of silicone spray fixes it.

Replacement Cost & What’s Included

A Mr-Glass-style window replacement in Plantation runs between $450 and $1,200 installed for most residential sizes. The range comes down to four things: glass package (single versus insulated versus impact-rated), frame material, sash versus full-frame replacement, and whether the opening needs reframing once we remove the old unit. We quote the part and labor separately on paper, so you see exactly what you are paying for. No line appears on the bill that was not on the written estimate. Both warranty layers get registered in writing before the truck leaves the driveway, and the work is covered by our Done Right Promise. If something is not done right, we make it right. No paperwork fight.

DIY or Call Us?

There are things an owner can safely check before calling: feel for drafts, look for fog, check whether the sash seats evenly in the track. What an owner should not do is attempt to replace a sash, balance assembly, or sealed glass unit on a Mr-Glass window. The balance systems in these windows hold significant tension, and a wrong move removing one can send metal parts flying. Glass packs are heavy and awkward and the tolerances are tight. We measure every opening twice, shim the frame back to square and level, and we do not leave until the sash moves right in both directions. If you want to know whether the window is a candidate for repair or a full replacement, call us at (772) 577-2915 and we will talk it through. A square deal, in writing, before anyone touches the window.

FAQs