Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterES Windows Sliding Glass & Patio Doors in Plantation: What to Know First
We’re an independent ES Windows service provider for sliding glass and patio doors in Plantation, and most repairs leave our shop with a same-week turnaround depending on part availability. A typical ES Windows track or roller replacement runs $220 to $480, while a full patio door swap lands between $3,800 and $7,200 depending on the series and size. This page is for Plantation homeowners who own an ES Windows door that binds, leaks, or won’t glide the way it did when it was new. If you’re dealing with a door you have to fight to close, call (772) 577-2915 for a free estimate.
How ES Windows Products Fail - and How We Fix Them
- ES Windows S-300 slider track wear. The S-300 series is common in Plantation homes built after 2010, and we regularly see the aluminum track groove widen under years of glass weight. The door starts to shimmy mid-roll, then the leading roller chews the track edge. We replace the track insert and both roller assemblies, not just the one that failed, because a worn track will kill a new roller in under six months.
- Roller carriage snap on the C-200 line. The C-200 uses a stainless roller carriage pressed into a plastic housing, and after eight to ten years of Florida humidity the housing embrittles and cracks. The door drops a quarter inch and scrapes the sill. We replace both carriages with an upgraded aftermarket set that keeps the manufacturer warranty intact on the glass and frame.
- Weep hole blockage causing sill rot. In Plantation’s wet season, ES Windows patio doors with plugged weep channels hold water against the sill track. We see this on doors that were caulked at the bottom by a previous installer who didn’t know the weep system needs open drainage. We clear the channels, verify flow, and re-level the sill so water runs out instead of under.
- Interlock seal flattening on the patio series. The felt and rubber interlock between the fixed and sliding panel compresses over time, especially on west-facing Plantation doors that bake in afternoon sun. You’ll feel air coming through the center seam even when the door is closed. We replace the interlock weatherstripping and adjust the panel alignment so the seal sits tight from top to bottom.
- Frame deflection from slab settling. Plantation sits on a mix of fill and muck, and concrete slabs move more than people expect. An ES Windows patio door set out of square by even a quarter inch will bind at the top corner and refuse to latch cleanly. Dale Kessler has spent years on tight-tolerance sliding glass door installs in Broward County, and our fix is to re-square the frame within shim tolerance before touching the hardware. If the frame is not square, no roller swap will save it.
Our ES Windows Sliding Glass & Patio Doors Process
- 1
Call and a person answers. You’ll speak with someone at (772) 577-2915 who can schedule a Plantation service call. No voicemail tree.
- 2
Diagnostic visit. A background-checked, uniformed technician measures the opening twice, checks the tracks, rollers, interlock, and frame squareness, and shows you exactly what has failed.
- 3
Parts decision on paper. We quote OEM ES Windows parts and quality aftermarket options side by side, with line-item pricing and the warranty implications of each. You decide with full information, not a sales script.
- 4
Repair or replacement. For single-visit jobs, we carry or source the needed hardware, replace worn components, re-level the panel, and lubricate with the right compound for Plantation’s heat and humidity.
- 5
Test before we leave. The door gets opened and closed a full cycle range with weight in the panel to simulate real use. If it does not glide square, level, and true, the job is not done.
- 6
Warranty registration in writing. Both warranty layers get registered before the truck leaves your driveway. Our Done Right Promise applies to every ES Windows job we put our name on.
What ES Windows Sliding Glass & Patio Doors Costs in Plantation
Here’s a straight answer on pricing in Plantation for ES Windows sliding and patio door work.
| Job | Typical Cost |
|---|---|
| Single roller replacement (parts & labor) | $95 - $180 |
| Track insert replacement | $180 - $340 |
| Interlock weatherstripping | $120 - $260 |
| Full hardware set (rollers, track, interlock) | $380 - $680 |
| Full sliding patio door replacement | $3,800 - $7,200 |
What moves the price: whether the frame is square, whether the glass panels need re-glazing, and whether OEM parts are specified. Our quotes are fixed and in writing. No surprise line items on the bill. Call (772) 577-2915 to schedule a free estimate.
Why Plantation Homeowners Call TruePane Windows & Doors for ES Windows Work
We’ve served Plantation and Broward County since 2008, founded by second-generation glazier Dale Kessler. He grew up off Broward Boulevard and learned the trade through the building trades program at McFatter Technical College in Davie. That matters because ES Windows doors are built to tight tolerances, and setting them square is a craft, not a guess.
Every job carries The Keystone Standard: both manufacturer warranty layers registered in writing, durations stated, and a Done Right Promise that says if it is not done right, we make it right. No paperwork fights. No arguing. We also install and service PGT, CGI, CWS, and ECO Window Systems, so if your ES Windows door is beyond repair, we can show you side-by-side quotes on alternatives that make sense for a Plantation home. If the pane is not true, the job is not done.
FAQs
In most cases, yes. We source OEM ES Windows parts when available, and we keep a catalog of aftermarket components that match the original specifications. For Plantation homes with doors older than fifteen years, we’ll show you both options on paper before ordering anything.
Call (772) 577-2915 and we’ll pull the door’s build details to check part availability.
No, when the repair is done correctly and documented. We register both warranty layers in writing as part of The Keystone Standard, and our work does not invalidate the manufacturer’s coverage on the glass and frame. We’ll tell you up front if a specific repair falls outside the warranty terms.
Call (772) 577-2915 for a free estimate and we’ll walk you through what your warranty covers.
It depends on what has failed. If the frame is still square and the tracks and rollers are worn, a hardware replacement is a $300 to $700 fix. If the frame has deflected from slab settling or the glass seal has failed, replacement starts to make more sense. We’ll tell you which path is cheaper over a five-year horizon, not just today.
Call (772) 577-2915 and we’ll show you both numbers in writing.
Most hardware repairs are completed in a single visit once parts are in hand, and we stock common ES Windows rollers, tracks, and interlock seals. If you call early in the week, we can usually get a technician to your Plantation home within a few days. A live person answers the phone 24 hours a day, 7 days a week.
Call (772) 577-2915 to get on the schedule.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Plantation and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.